EVEREST LABS

KRYO

KRYO SETUP RESOURCES

Set up KRYO once. Use it daily.

Everything you need to set up KRYO correctly the first time: placement, filling, first cooldown, power routing, care, and support.

Start setup Get support
15 minZero-drill placement and connection
8-12 hrFirst full cooldown window
30 secYour daily cold reset

START HERE

Your first setup, simplified.

Follow these four steps before your first cold session. Then let KRYO complete its first full cooldown overnight.

1

Place

Set KRYO inside a wet room, walk-in shower, or bathtub. Keep it away from direct overhead flow where possible.

2

Connect

Attach the hose, adjustable wall mount, and high-coverage halo. Keep the hose path clean and kink-free.

3

Fill

Fill the reservoir using your shower hose, bath hose, bidet hose, or jug. Replace the cap before powering on.

4

Power

Plug the power supply into a standard outlet outside the wet area, then route the low-voltage cable to KRYO.

FIRST USE

Set it up the night before.

Your first cooldown is the longest one. Once KRYO reaches temperature, it is built to stay ready inside your routine.

✓
Place the unit and connect the halo before filling.
✓
Keep the power supply outside the wet area.
✓
Allow 8-12 hours for the first full cooldown.
✓
Top up water every 3-5 sessions, depending on use.

TIMELINE

What to expect after unboxing.

0-15 min

Physical setup

Place the unit, mount the halo, attach the hose, route the cable, and fill the reservoir.

8-12 hr

First cooldown

Let KRYO pull the reservoir down to cold temperature before the first session.

Morning

Press and step in

Use KRYO where your day already starts. No ice, no plunge tub, no reset project.

3-5 uses

Top up

Add water through the fill cap as needed, then keep the system ready for the next session.

Inside the box

  • KRYO 2.0 cooling unit
  • High-coverage halo
  • Adjustable wall mount
  • 1.5m flexible hose
  • Dubai 48V power kit with UAE plug
  • Low-voltage bathroom-side cable
  • Cable routing accessories where included

Power placement

  • Keep mains power outside the wet area.
  • Route only the low-voltage cable to KRYO.
  • Use the cable cover for a cleaner wall or floor path.
  • Do not plug the power supply into a bathroom shaver outlet.
  • Keep the connector dry before fastening it to the unit.

TROUBLESHOOTING

Common first-week questions.

Why is the first cooldown slow?

The first cooldown starts from room-temperature water. Set up KRYO the night before and allow 8-12 hours before your first session.

Where should the power brick go?

Outside the wet area, such as a bedroom, hallway, or dry outlet location. Only the low-voltage cable routes to the bathroom-side unit.

How often do I refill?

Top up every 3-5 sessions depending on session length, splash-out, and how much water remains in the reservoir.

What if flow feels weak?

Check the reservoir level, hose connection, and hose path. Remove any tight bend or kink before running another session.

Need help setting up your KRYO?

Send a photo of your bathroom layout and our team will help you choose the cleanest placement, hose path, and cable route.

Contact a KRYO Expert